Automatización de una pileta de agua mediante un PLC Master K 120s para obtener una secuencia de chorro de agua tipo cristalino.

Abstract

In this project, a water pool is automated by means of a PLC Master K 120s, for this, relevant information is sought about concepts and definitions on which the work is based, such as an introduction to automated systems, definitions of plc and the concepts of a pool of water and its components; After the necessary theory is presented and analyzed, the project design is carried out as such, starting with the structure of the water basin, the control panel and the creation of the program with which the plc controls the project. The sequence by which the crystal-clear water jets from the water basin are governed works as follows: As soon as power is supplied to the system, it is ready to operate and the water begins to flow through 4 nozzles according to the program in the PLC for 10 seconds. Afterwards, one of them will stop flowing and the other three will continue to flow for 5 seconds. Then again the second will stop flowing and the other two will continue to flow and the system will continue in the same way. And after finishing a cycle, 4 nozzles will stop flowing. The cycle will start to flow over and over again. It is concluded that for the automation of a water pool with crystalline jets a harmonic and orderly sequence is necessary, therefore these pools are used as decoration for places with quiet environments.